Home > Onkyo Tx > Onkyo Tx-nr609 Net Not Working

Onkyo Tx-nr609 Net Not Working

Contents

I cannot spend £450.00 right now. Opposite end of Gary... Tried a firmware update via USB. Tales of dropped sound / no network issues, often referred to as the "HDMI board issue" have become commonplace in message boards and Onkyo's Facebook/Twitter accounts. check over here

Jump to Forum Index Custom Installation World Custom Installers' Lounge Discrete Code Hunter Graphics & User Interfaces RS-232 & IP Control The Job Marketplace Professional Remote Controls General Pro Remotes Complete But is this only for European customers? The dealer said to send this unit back. but) I upgraded to this unit from a Denon 4310 for 3D ability. http://www.avsforum.com/forum/90-receivers-amps-processors/1361472-onkyo-tx-nr609-dhcp-problems.html

Onkyo Tx-nr609 Now Initializing

I know my receiver was hit hard for a lot of people with this issue and mine is eligible for this program. Top Sat, 2012-03-24 09:58 #3 jonathanRD Offline Last seen: 1 day 19 hours ago Joined: 27/01/2011 - 19:45 Posts: 863 RE: Onkyo 609 network access problem My retailer Sevenoaks agreed to Hope it saves someone else some time![/quote] longmontmatt is offline Quote Remove Advertisements Sponsored Links AVS Forum Advertisement Reply Receivers, Amps, and Processors Tags Onkyo Tx Nr609 7 2 One day when I tried, it just wouldnt work.

abernat Wise, Aged Ars Veteran Tribus: Mountain View, CA, USA, Terra, Sol Registered: Jan 11, 2005Posts: 195 Posted: Wed Oct 23, 2013 3:03 pm Yup; unplugging and re-plugging didn't help. Shipping is annoying expensive, but cheaper than a new receiver. What happens is, I have it connected with an Ethernet cable, unit does show an IP address, gateway and all info is correct. Onkyo Tx-nr609 Recall It had been working well until I tried to get internet radio working yesterday.

To address the problem and help people who may have an Onkyo Brand receiver manufactured between 2009 and 2012 and affected by loss of audio or loss of network connection („Impacted Onkyo Tx-nr609 Factory Reset I expected them not to fix it. This is the second unit I have recieved. check over here However, I could unplug the unit and then it would work This is no longer the case.

Today 10:01 AM by Verge2 7k 10745 Attachment(s) *Official* Marantz 2015 NR-1506/1606, SR-5010/6010/7010 &... Onkyo Tx-nr609 Network Greyed Out about 1782 days ago View tweet. The unit is mint, never driven hard or had anything on top of it. DId a lot of trouble shooting - 1.

Onkyo Tx-nr609 Factory Reset

zillch 24 5.1 setup recs for ~$800 (Budget for speakers+receiver... http://forums.onkyousa.com/viewtopic.php?t=5947&p=22183 This integra I understand has dual power supplies and seems to drive my setup sweetly. Onkyo Tx-nr609 Now Initializing Reenabling DHCP and saving the settings would get you back on the network in this case.Good luck,--MikellamasPosts : 6Join date : 2012-01-23 Re: TX-NR609 ethernet network connection suddenly lostEVLHSV on Onkyo Tx Nr609 Problems At least 7-8 HDMI inputs would be great but I could reduce it by going through the OPPO if required.

Most likely the firmware update didnt have anything to do with my issue as my net connection in 609 was working before the update. http://cestudios.net/onkyo-tx/onkyo-tx-nr515-usb-not-working.html My 818 was acting up and I was very glad to read this is known, acknowledged and in your case, fixed! New firmware updates available for TX-NR579, TX-NR609, HT-R990, TX-NR709, TX-NR809, TX-NR1009, TX-NR3009, TX-NR5009, PR-SC5509, PR-SC5508! just not acceptable. Onkyo Tx-nr609 Hdmi Board

checked the router admin page and connected clients list. FFcossag 9,606 views 4:50 Onkyo TX-NR709 receiver hair dryer resurection - Duration: 8:22. The 609 Mac address was listed as one of the connected clients. this content any ideas???EVLHSVPosts : 4Join date : 2012-02-10 Re: TX-NR609 ethernet network connection suddenly lostOnkyoUSA on Fri Feb 10, 2012 5:41 pmHi EVLHSV,Do you get an valid ip address from your

The snaps and pops are worse when there is no sound, like between songs on Pandora. Onkyo Tx-nr609 Network Setup The complete shutdown, forced it to clear all memory and start from scratch, clearing the DHCP issue. 11. I dont need massive features as I think I do it all outside of the Reciever but sound quality needs to be paramount.

You need to go to the site and enter your info to be sure.

Then I realized that all this while I had been only doing a soft reboot by using the power off switch on the receiver which still kept the HDMI pass thru Look up how to do that and give it a try. Gary Juergens 4,907 views 8:02 Onkyo "no sound"Repair Guide for "dummies" - Duration: 4:49. Onkyo Tx-nr609 Firmware For music in general I use my SONOS unless listening to Vinyl...ok so why the post if it is getting fixed.

ers-threadWill be able to help you out in that regard.Of course, with the network dead, you need a PC with RS232 port and probably WinXP to reflash the Firmware.Onkyo themselves seems Integra 50.4 is 2 years old roughly, no sound issues at bootup, tec-support has offered to fix it for free. (good... Sat runs through the xbox so I dont know if it looks great because of the Integra or because of the XBOX One. have a peek at these guys Until now it hasn't shown any problems yet, but if it does before the end of 2018 I know I will be coverd, very comforting news!

Opposite end of Gary... I bought a WD media streaming box and it connected immediately. Go to the site linked, it asks for some information, which includes the units serial number, it then gives you a response as to whether your device is eligible or not. Rob Cuypers 164,740 views 4:49 How To: Prevent Onkyo "No Sound Problem" - Duration: 5:57.

Working... I thought I would get my £499.95 I paid for (Onkyo will only give £100.00) and purchase TX-NR646 for £549.00 with free Atmos speakers. Surprisingly, last night I wanted to try one more time before contacting you ad I heard the relay to run on the speakers. I believe my current problem is a known problem with this model and would like to know how Onkyo could help me because I think less than 3 years is a

I know the switch works, I know each of the ethernet cables works, and tried connecting the receiver directly to my router. worked fine. Hope this helps SD JVC DLA-X35B 3D Projector, Elunevisions Reference 92 inch 4K Tab-Tensioned, Goldenear Triton II's, Goldenear SCXL, Mirage OS1 X4, Mirage Nanosats Prestige X2, Monoprice 4102 in ceiling speakers Comment 12 Kev Tredway On 21.6.2015 - 3:18 Dear Onkyo.

All this was 2 days of frustration and tinkering around. Kev31779 99,297 views 24:02 How To Fix the Onkyo TX SR606 & SR607 HDMI Input Problem - Duration: 6:43. Digital Hi-End Projectors - $3,000+ USD MSRP Rear Projection Units OLED Technology and Flat Panels General OLED Technology Great Found Deals! Speaker Systems TV Speaker Systems Bluetooth Speakers Accessories Headphones Headphone Amplifiers Applications Support Support for your Onkyo product.

No errors, just a blank screen and a blank display on the receiver. is not responsible for, and disclaims any and all liability for the content of comments written by contributors to the forum. Blu-ray reviews:2 There is no cheap receiver(receiver, not "amp") with separate power supplies. Home Theater Gear Projector and Screen: Infocus X10 with Celexon HomeCinemaLine 72" Receiver: Onkyo TX-SR707 Front Speakers: Chario Hiper 2000T Center: Chario Hiper Dialogue Surround Speakers: Monitor Audio RXFX Dipole mode

johneee Ars Scholae Palatinae Registered: Jun 17, 2002Posts: 733 Posted: Tue Oct 22, 2013 1:44 pm Silly question, but have you tried unplugging it and plugging it back in?I have the AMP drive, so power supplies and the actual amp output as well. The machine is almost exactly two years old.